Scale pdf page content using command line

You are certainly allowed to adjust page content because the pdf reader has already pre-set for you. But when you meet with some fixed page content, for example, scaling page content to 60% of the page width and 70% of the page height, or even strict ones, how could you achieve it? The VeryPDF.com offers you an easy way to scale pdf page content using Advanced PDF Tools Command Line, with which you are free to scale pdf page content. The procedures go below:

First, follow this link you will obtain this useful tool

https://www.verypdf.com/pdfinfoeditor/advanced_pdf_tools_cmd.zip.

do remember to extract it, for it is a zipped package.

Second, launch the MS-DOS command prompt window

steps are as follows:

start the dialog box of “cmd.exe”: press  “start”>choose “Run”>input “cmd”>press “ok”

when the following appearing, you will have the MS-DOS command prompt window

Snap1

Third, input the command to edit pdf page content 

pdftools -i "C:\input.pdf" -o "C:\output.pdf" -j "60% 70% true"    

where –j is to specify set page content, "60% 70% true"  the first parameter means to set page content to 60% of the page width and the second parameter to 70% of the page height, and the third parameter is a Boolean type value to set whether to center on page. 

once the input is finished, press “enter”, you are allowed to see

Snap188

Fourth, open the file to check, screenshots again

Snap192 Snap189

the sharp contrast shows you succeeded in scaling page content to 60% of the page width and 70% of the page height and the page content has been centered.

VN:F [1.9.20_1166]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.20_1166]
Rating: 0 (from 0 votes)

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *


Verify Code   If you cannot see the CheckCode image,please refresh the page again!