is an expert on converting and setting . It has gained widely popularity among people who used it before. To make more people master the skill of using , the VeryPDF.com uses this article to illustrate how helpful this tool is.
Downloading&Installing PCL Converter command line
Click the link to open http://www.verypdf.com/pcltools/index.html, and then download VeryPDF PCL Converter command line. when you begin to install PCL Converter , you are bound to see below window box.
There are two ways to experience PCL Converter command line: one is to press “try”, the other one to press “Buy now”. The former one means you are entitled 50times free of charge to experience this wonderful software. The latter one means you purchase it for permanent use.
Launching the MS-DOS command prompt window
The way to launch MS-DOS command prompt window is easy, and the following pictures will guide you.
Press “start”>choose “Run”>input “cmd”>press “ok”
Enter cmd as the picture indicates,
Press “ok”, you will have the MS-DOS command prompt window.
Input the command line to convertand set , it goes below
pcltool.exe -width 800 -height 600 C:\in.pcl C:\out.bmp
- C:\in.pcl is to specify a pcl filename or a directory for input,
- C:\out.bmp is to specify the bmp file name for output.
- width 800 -height 600 is to set page size width to 800 and height to 600.
Once the input is done, press “enter” key, you will see,
When you see “result=ok”, it means the program has gone through.
Open the output file to check if pcl has been converted to bmp file withchanging , see below contrast.
From the above picture, you can safely say that you are successful in converting pcl to bmp and setting page size.