Convert px3 to jpg and set page size via command line?

If you had not a helpful tool to assist you, the converting task would be tedious. The VeryPDF.com offers you PCL Converter command line and under its help, you are allowed to change the filename extension, such as pcl, ps and px3, etc. to your desired one or ones, such as jpg,tif, pdf and so on. Although this process is bound to be finished in command prompt window (see Picture command prompt window), it is still extremely simple to convert px3 to jpg and set page size. You may think it magical, it is real by using PCL Converter command line, go for experiencing!

Downloading&Installing PCL Converter command line

  1. click the link to open http://www.verypdf.com/pcltools/index.html
  2. go to  VeryPDF PCL Converter command line
  3. press “Download” and save file

During the installing process, you are bound to see below window box.

installing interface of PCL Converter command line

There are two ways to experience PCL Converter command line: one is to press “try”, the other one to press “Buy now”. The former one means you are entitled 50times free of charge to experience this wonderful software. The latter one means you purchase it for permanent use.

Launching  command prompt window

You have to launch  command prompt window. Because the command line is bound to be operated under the MS-DOS environment. The procedure is easy, and the following pictures will guide you.

Press  “start”

Press  “start”

Choose “Run”

Choose “Run”

Input “cmd”

Input “cmd

Press “ok”, you will have the command prompt window.

command prompt

Inputting command line

Input the command line to convert px3 to jpg and set page size, it goes below

pcltool.exe -width 800 -height 600 C:\in.px3 C:\out.jpg

where

  • C:\in.px3 is to specify a px3 filename or a directory for input,
  • C:\out.jpg is to specify the jpg file name for output,
  • width 800 -height 600 is to set page size width to 800 and height to 600.

Once the input is done, press “enter” key, you will see,

detailed operation of command line

                    Picture command prompt window

When you see “result=ok”, it means the program has gone through.  

Checking file

Open the output file to check if px3 has been converted jpg file and  how the page size changed

jpg file

jpg file   

So far, you have successfully converted px3 to jpg and set page size. For inquiry, please visit at www.verypdf.com.

VN:F [1.9.20_1166]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.20_1166]
Rating: 0 (from 0 votes)

Related Posts

This entry was posted in VeryPDF Blog and tagged , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *


Verify Code   If you cannot see the CheckCode image,please refresh the page again!