I want to convert the 1st page of pdf to emf, what should I do?

Enhanced Windows Metafile(. emf) is a windows vector graphics format recognized by many image-editing applications. EMF is basically a 32-bit version of the original Windows Metafile Format (. wmf), which only supports 16-bit data. EMF saves image data in an RGB format and it does not support CMYK data.

The paragraph above is a brief introduction about EMF image format, in the following paragraphs, I will show you how to convert the 1st page of pdf to emf in PDF To Image Converter, which is a powerful converter on converting pdf to image.

Step1. Please open your file in PDF To Image Converter v2.1:

click the open button on the toolbar in the preview panel of PDF To Image Converter v2.1, a dialog box is popped out, then please choose your pdf there and click “Open” button in that dialog box, so you will see your pdf file is shown in the preview panel.

快照245

快照238

You could use the tool buttons of toolbar to review your pdf in PDF To Image Converter v2.1, which is marked by the red frame in the figure above.

Step2. Please add your pdf route into the batch process table:

click “Add” button, another dialog box pop out, likely, please select your pdf there by double-click it, then your pdf route will be shown in the form of batch process of PDF To Image Converter v2.1.

快照240

快照241

In the figure above, you could see that this pdf contain 2 pages, which is shown in “Page Count”.

Step3. Please assign an converting format and a space for your emf:

click the edit-box of “File type”, a dragging list appear then, and you could choose EMF to be your target format; click the edit-box of “Destination folder”, and input a folder route, which represent a space in your pc.

快照242

Step4. Please set a converting range:

in step2 we mentioned that the page count is 2, so in this step click the check-box of “Page range”, which is relative to page count, and click the edit-boxes of “From” and “To”, where you can input the same value 1, which is the guarantee on only converting the 1st page of pdf in PDF To Image Converter v2.1.

快照243

Step5. Please process this task about converting pdf to emf in PDF To Image Converter v2.1:

click “Convert” button in the panel of PDF To Image Converter v2.1, then close this converter through clicking “Exit” button. When you open your destination folder, you will find your emf image there.

快照244

VN:F [1.9.20_1166]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.20_1166]
Rating: 0 (from 0 votes)

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *


Verify Code   If you cannot see the CheckCode image,please refresh the page again!