Convert pcl to jpeg and set page size via command line?

If the page size of your jpeg file dose not fit you, you are bound to set the page size according to your requirements. This article will show you how to set page size when you convert pcl to jpeg via PCL Converter command line.

Click the following link to download PCL Converter command line

Note, there are two ways to experience PCL Converter command line: one is to press “try”, the other one to press “Buy now”. The former one means you are entitled 50times free of charge to experience this wonderful software. The latter one means you purchase it for permanent use. You take below picture as reference.

installing interface of PCL Converter

Input command line to convert pcl to jpeg and set page size

The way to input command line is pretty easy, do Justas the following picture indicates,

Press  “start”>choose “Run”>input “cmd”>press “ok”

way to launch MS-DOS command prompt window

Here goes the crucial step, you have to make sure the command line you are going to input accurate.

pcltool.exe -width 800 -height 600 C:\in.pcl C:\out.jpeg

Once the inputting is done, press “ok”, you are allowed to see

command line

Open your file to check the difference between two files

To achieve sound effect, the VeryPDF.com makes a comparison below.

jpeg file

jpeg file  

The above picture show the page size before setting while the below one after setting.

VN:F [1.9.20_1166]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.20_1166]
Rating: 0 (from 0 votes)

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *


Verify Code   If you cannot see the CheckCode image,please refresh the page again!