Convert documents of RTF to PDF and set PDF title by command line

To convert the document of rtf to pdf and set PDF title, there is a practical application which will do this work perfectly for you. The conversion is made up of three steps: opening MS-DOS prompt window, inputting command line, running the conversion. You will see the specific conversion steps in this article.

Before the conversion, you need to download the command line application to be used in the conversion from rtf to pdf. The command line application is the internal one in Document Converter which is a professional document converter. The command line application is able to convert any printable documents to various image formats. You can also use it to set different parameters for the target file.

The free download link is https://www.verypdf.com/artprint/docprint_pro_setup.exe.

After downloading it to your computer, please set up it on the disk until you can see the executable file doc2pdf.exe which is the called program of the conversion in installation directory.

Firstly, please open MS-DOS interface for inputting the command line. You can press “Window”+ “R” or click “Start”—“Run” to open “Run” dialog box in which you are able to input “cmd” in “Open” combo box and click “OK” button.

Secondly, you need to input the command line in MS-DOS interface. The command line has four parts: called program, parameter for setting PDF title, source file and target file. In the command line, you should use the path of each file just like the following example.

"C:\Program Files\docPrint Pro v5.0\doc2pdf.exe" –t “book” –i “C:\Documents and Settings\a.rtf” –o “C:\Documents and Settings\a.pdf”

In this command line,

"C:\Program Files\docPrint Pro v5.0\doc2pdf.exe" is the path of called program doc2pdf.exe.

–t “book” is the parameter for setting PDF title, which means the title of the created PDF document will be set as “book”.

–i “C:\Documents and Settings\a.rtf” is the path of source file.

–o “C:\Documents and Settings\a.pdf” is the path of target file which is the one you should set yourself.

When you input the paths in the command line, you can directly drag the file you need into MS-DOS prompt window for getting the path for convenience instead of inputting them word by word. Then please click “Enter” button to run the conversion from rtf to pdf.

For purchasing the command line application, you should click the following link: https://www.verypdf.com/order_docprintpro.html.

VN:F [1.9.20_1166]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.20_1166]
Rating: 0 (from 0 votes)

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *


Verify Code   If you cannot see the CheckCode image,please refresh the page again!