Cannot launch pdf2vec


I'm currently evaluating pdf2vec. I was able to run this on my w7 pc but not on my w2003 server where I'm running additional tests.

the error message is:   0xc0000005 the application failed to initialize

Also when running this on w7 I call it from another program, but in this case the program hangs.

When I run this from my dos shell it works fine.

Is there some limitation for the trial version?




Please turn off DEP for "pdf2vec.exe" application to try again, please refer to following steps about how to turn off DEP in your system,

1. Click "Start"
2. Select "Control Panel"
3. Select "System"
4. Click the "Advanced" tab
5. In the "Performance" region select "Settings"
6. Click the "Data Execute" tab in the dialog box that opens
7. Select "Turn on DEP for all programs and services except for those I select"
8. Click "Add"
9. The open dialog box will open. Browse and select "pdf2vec.exe" application in your computer,
10. Click "Open"
11. Click "Apply"
12. Click "Ok"
13. Reboot

OK, you can run "pdf2vec.exe" without any problem now, please to try.

Please don't hesitate to contact us if you have question on this.

Thank you!

Best regards,
Services Support Team
PDF Creation, PDF Converter, etc. Products:
Postscript, PCL, DWG, DXF, HTML, Metafile, Office, etc. Products:

VN:F [1.9.20_1166]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.20_1166]
Rating: 0 (from 0 votes)

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *

Verify Code   If you cannot see the CheckCode image,please refresh the page again!