Special requirements to PDF STAMP command line

Hello,
I am testing your product and it is getting very close to meeting my requirement.  I need to place an image on every even page AND place another image on the 1st 2nd and page.Is this possible?  I tried the command below, however it is assuming both images on every even page.

C:\DocuStamp\bin>pdfstamp.exe -PDF "cert-11.pdf" -o "testimage.pdf"  -AI "cutmark.jpg" -p1 -mlr50 -mtb50 -SR -S-2 -E-2  -AI "yellow.jpg" -p2  -SR -S1 -E2

Please let me know if this is possible in one pass.
=========================
Thanks for your message, this is not possible in one command line, however, you can use two command lines to implement this function, you can run one command line to add first stamp, and run another command line to add second stamp, then you will able to insert these stamps into PDF pages properly.

VeryPDF

VN:F [1.9.20_1166]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.20_1166]
Rating: 0 (from 0 votes)

Related Posts

This entry was posted in PDFStamp Command Line and tagged , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *


Verify Code   If you cannot see the CheckCode image,please refresh the page again!